Freaking out about Sci-fi & Moives

Archive for 30/04/2018

Stirling Class W.I.P part 4

Another week of work on this but not a lot to show but a lot done.
I have rebuilt the saucer section for the third time, before I found that the edges where to sharp. When I used the Boolean tool it just buggered everything up.
So to get ride of the sharp edges I remodelled it again. This also meant that out edge of the hull is now a deck and half high instead of a deck. I was hoping to make it two decks high. But when I did this it really did not site well with the rest of the ship. This would of meant sizing that and I really did not want to go down that road. So I am happy with that.

I modelled the Phaser strips that would go around the top most of the hull. I had some issues with getting it to sit right. As it stands at the moment part of it sitting correctly but the other part either going into the hull or hanging just over it. So I am going to play around with that to get it right. Funny thing is when I used the same technique with the lifeboat hatches it work. So I am thinking there most be some sort of issue with the curve tool or how I am using it.

I have also modelled an airlock onto the side of the saucer, it bigger than your normal crew airlock, reason being it would be used to get large cargo into the ship or large equipment that would not fit though a standard airlock. The airlock door still needs details added to it.

The impulse engines have also been modelled and I am happy with their look, I also add in some details around it but more it needed.
RCS have been added, the rear ones are on top of the impulse engines. I don’t see this being a issue as the impulse engineer don’t exert any gasses to propel the ship forward as it is suppose to be some sort of “gravity drive”. In another words it pulls the ship and push like a rocket would.

Last but not least, I have modelled the defector and add in two set of Plush Phaser Canons and some details around this as well, but more details are needed. I have also added some hull panels just to get an idea on how to do it. I am liking the look but I think the cuts between the panels are too big.

Next up is to cut in the windows and hull platting for the rest of the top side of the saucer. Once that is done I will start work on the bottom and start thinking about add in more details.

On a side not this ship currently has 22 life boats installed in the saucer alone. Each life boat can hold up to 8 people. this means that there is room for 176 people to escape if needed. I see this ship being crewed by 150. I still need to put some lifeboats into the secondary hull, so this thing has more than enough room for extra people.

Advertisements